Here you have the option to configure a sender address for the device to use in place of the one that would otherwise be used automatically for this target address.
If you have configured loopback addresses, you can specify them here as source address.
Note: If the list of IP networks or loopback addresses contains an entry named "DMZ" then the associated IP address
will be used.
- SNMP ID:
- 2.12.29.11
- Console path:
- Setup > WLAN > RADIUS-Access-Check
- Possible values:
Name of the IP networks whose address should be used, any valid IP address, or the name of a loopback address.
