Here you can optionally specify another address (name or IP) used by your device to identify itself to the remote WLC as the sender.
By default, your device sends its IP address from the corresponding ARF context, without you having to enter it here. By entering an optional loopback address you change the source address and route that your device uses to contact the remote site. This can be useful, for example, if your device is available over different paths and the remote site should use a specific path for its reply message.
Note: If the source address set here is a loopback address, these will be used on the remote client. unmasked !
- SNMP ID:
- 2.37.34.3.2
- Console path:
- Setup > WLAN-Management > WLC-Cluster > Static-WLC-List
- Possible values:
Max. 16 characters from [A-Z][0-9]@{|}~!$%&'()+-,/:;<=>?[\]^_.
- Special values:
- Name of the IP network (ARF network), whose address should be used.
- INT for the address of the first Intranet
- DMZ for the address of the first DMZ
-
Note: If the lists of IP networks or loopback addresses contains an interface named 'DMZ', then the device selects the associated IP address instead!
- LB0…LBF for one of the 16 loopback addresses or its name
- Any IPv4 address
- Default:
- empty
