Loopback-Addr.

Here you can optionally specify another address (name or IP) used by your device to identify itself to the SYSLOG server as the sender. By default, your device sends its IP address from the corresponding ARF context, without you having to enter it here. By entering an optional loopback address you change the source address and route that your device uses to contact the remote site. This can be useful, for example, if your device is available over different paths and the remote site should use a specific path for its reply message.

Note: If the source address set here is a loopback address, this will be used unmasked even on masked remote clients.
SNMP ID:
2.17.20.5 
Telnet path:
Setup > DNS > Syslog
Possible values:

Max. 16 characters from [A-Z][0-9]@{|}~!$%&'()+-,/:;<=>?[\]^_.

Special values:
Name of the IP networks whose address should be used
"INT" for the address of the first Intranet
"DMZ" for the address of the first DMZ
LB0 to LBF for the 16 loopback addresses
Any valid IP address

www.lancom-systems.com

LANCOM Systems GmbH | Adenauerstr. 20/B2 | 52146 Wuerselen | Germany | E-Mail info@lancom.de

LANCOM Logo