Specifies which communities the device removes from an NLRI.
Communities are specified by means of a comma-separated list (<AS-number1>: <Value1>,<AS-number2>:<Value2>,<AS-number3>:<Value3>).
Note: Known communities are not removed from NLRI. Known communities are:
- no-peer
- no-export
- no-advertise
- no-export-subconfed
The following input formats are available for communities:
| Input format | Community |
|---|---|
| 1:2 | Standard community |
| 1.2.3.4:1 | IPv4-specific extended community |
| roc:1.2.3.4:1 | IPv4-specific route origin extended community (Site-of-Origin (SoO)) |
| rtc:1.2.3.4:1 | IPv4-specific route target extended community |
| ext2:1:2 | Two-byte AS extended community |
| ext4:1:2 | Four-byte AS extended community |
| roc:1:2 | Two-byte AS route origin extended community (Site-of-Origin (SoO)) |
| rtc:1:2 | Two-byte AS route origin extended community |
| roc:ext4:1:2 | Four-byte AS route origin extended community (Site-of-Origin (SoO)) |
- SNMP ID:
- 2.93.1.5.2.3.4
- Telnet path:
- Setup > Routing-Protocols > BGP > Policy > Overrides > Communities
- Possible values:
Max. 62 characters from [A-Z][a-z][0-9]#@{|}~!$%&'()*+-,/:;<=>?[\]^_. `
- Default:
- empty
