Here you can optionally specify a loopback address for the device to use as the target address instead of the one that would normally be selected automatically.
Note: If the list of IP networks or loopback addresses contains an entry named "DMZ" then the associated IP
address will be used.
Important: If the source address set here is a loopback address, this will be used unmasked even on masked remote
clients.
- SNMP ID:
- 2.2.35.10
- Console path:
- Setup > WAN > L2TP-Endpoints
- Possible values:
Name of the IP networks whose address should be used, any valid IP address, or the name of a loopback address.
