2.39.6.1.5 Source interface

This is where you can configure an optional sender address to be used instead of the one otherwise automatically selected for the destination address.

If you have configured loopback addresses, you can specify them here as sender address.

Telnet path:
Setup > Certificates > OCSP-Client > CA-Profile-table
Possible values:
  • Name of the IP network (ARF network), whose address should be used.
  • INT for the address of the first Intranet
  • DMZ for the address of the first DMZ
    Note: If the list of IP networks or loopback addresses contains an entry named 'DMZ', then the associated IP address will be used instead.
  • LB0…LBF for one of the 16 loopback addresses or its name
  • Any IPv4 address
Note: If the sender address set here is a loopback address, these will be used unmasked on the remote client!
Default:
0.0.0.0

www.lancom-systems.com

LANCOM Systems GmbH | A Rohde & Schwarz Company | Adenauerstr. 20/B2 | 52146 Wuerselen | Germany | E‑Mail info@lancom.de

LANCOM Logo