Overview of CAPWAP parameters with the show command

The following information about the CAPWAP service can be viewed using the command line:

Table 1. Overview of all CAPWAP parameters with the show command
Parameters	Meaning
`-addresses [<IfcNum>]`	Shows the address tables of an individual or all WLC tunnels. In the case of an individual WLC tunnel, enter for the `<IfcNum>` the number of logical WLC tunnel interface, for example `10`.
`-groups`	Shows the information for an individual or all available assignment/tag groups.

You can supplement the command show capwap groups with the parameters listed below, which control the scope of the displayed information:

Table 2. Overview of all CAPWAP group parameters with the show command
Parameters	Meaning
`all`	Shows the names configured in the setup menu and the device's internal names for all assignment/tag groups as well as the default groups that were set up. The default group represents an internal group which contains all APs.
`<group1> <group2> <…>`	Shows all APs of the respective assignment/tag groups.
`-l <location>`	Shows all APs of the respective location.
`-c <country>`	Shows all APs of the respective country.
`-i <city>`	Shows all APs of the respective city.
`-s <street>`	Shows all APs of the respective street.
`-b <building>`	Shows all APs of the respective building.
`-f <floor>`	Shows all APs of the respective floor.
`-r <room>`	Shows all APs of the respective room description.
`-d <device>`	Shows all APs that have the specified device name.
`-v <firmware>`	Shows all APs which have the specified firmware. To do this, enter the version number for `<firmware>` followed by the build number, e.g., `9.00.0001`.
`-x <firmware>`	Shows all APs with a firmware version lower than the one installed on the current device.
`-y <firmware>`	Shows all APs with a firmware version the same or lower than the one installed on the current device.
`-z <firmware>`	Shows all APs with a firmware version higher than the one installed on the current device.
`-t <firmware>`	Shows all APs with a firmware version the same or higher than the one installed on the current device.
`-n <intranet>`	Shows all APs with an IP belonging to the specified Intranet address.
`-p <profile>`	Shows all APs that have been assigned with the specified WLAN profile.
`rmgrp <group1 intern_name> <group2 intern_name> …`	Deletes the group(s) with the specified internal names from the memory of the device. Use this command to free up the main memory if too large a number of groups is degrading the performance of the device. The entry in the setup menu is unaffected by this action.
`resetgrps`	Deletes all groups except the default group.

For location information the device evaluates the information entered under Location in the access point table. The following field names are available:

co=Country
ci=City
st=Street
bu=Building
fl=Floor
ro=Room

For instance, the location entry co=Germany, ci=Aachen allows you to list all of the managed APs in Aachen from the console of the WLC with the command +show capwap group -i Aachen.

Example commands

show capwap group all
show capwap group group1
show capwap group -l yourlocation
show capwap group -s yourstreetname
show capwap group -d yourdevicename
show capwap group -p yourprofilename
show capwap group -d yourdevicename -p yourprofile -v yourfirmversion …